ANCHOR POINTS
Kattsafe AP110 Tension Anchor Point
Single Plate, Non-Weld Tension Anchor
The Kattsafe AP110 tension anchor is a unique single plate, non-weld device that can be used in direct tension or shear for overhead applications.
The tension anchor is designed to be used at angles greater than 20 degrees and constant tension, and is engineered for rope access use in overhead and re-belay applications under facade overhangs, as well as general fall arrest use. It can be installed onto concrete or steel structures.
Key product features:
- Fall arrest/re-belay use
- Rated to 21kN single person use
- Break test peak load rating of 50kN
- Overload indicator
- Rescue capabilities
- Lightweight & compact
- Unique single plate no-weld device
- Weight: .7kg
COMPLIANCE
DOWNLOADS
Key product features
- Fall arrest/re-belay use
- Rated to 21kN single person use
- Break test peak load rating of 50kN
- Overload indicator
- Rescue capabilities
- Lightweight & compact
- Unique single plate no-weld device
- Weight: .7kg
Installation details
Installation must be carried out by an accredited Kattsafe Fall Protection Certified Technician, and in accordance with the manufacturer’s installation instructions. It can be installed during roof construction or as a retrofit from the top of the roof surface.
Product warranty
10 Years from the date of purchase, subject to correct installation. Use and maintenance to be in accordance with the manufacturer’s specifications and recommendations. (This excludes wearing parts).
Terms & Conditions:
All warranty claims must be made in writing within 14 days of the appearance of the defect.
Testing & Approvals
-
Testing and performance based on AS/NZS 1891.4:2009 & AS/NZS 5532:2013
-
Dynamic load test 15kN
-
Static load test – 15kN
-
Ultimate static load test – 50kN+
-
Single person use installed rating: 21kN
-
Break test peak load rating: 50kN
-
Rescue can be performed off the same anchor if the situation permits
The Whole Height Solution.
From The Team You Already Trust.
Thinking of your next project? Let's chat.
COMPLIANCE
-
The Tension anchor is designed and manufactured in accordance with requirements of AS/NZS 1891.4:2009, AS/NZS ISO 22846 and AS/NZS 5532:2013