Hey there! It looks like you're visiting our New Zealand website.

Would you like to switch to Australia?

Go to AU website
or continue on NZ website..

DAVIT & NEEDLE SYSTEMS

3M Davit Arm

Removeable Lifting & Lowering Device Up To 500kg

Davits & Needles

The 3M Davit Arm is a fully modular lifting and lowering device that is environmentally resistant.

The 3M Davit Arm can be used for lifting loads up to 500kg or for personal protection, up to three people at the same time. PSD Arm System is made of stainless steel.

HOW IT IS USED

The 3M Davit Arm is a removable device that can be placed in predetermined positions to allow access to hard-to-reach places. 

HOW IT WORKS

The 3M Davit Arm is used where there is a need to project an abseil rope out over the edge of a building without impacting the facade, parapet, or possibly a glass balustrade. Davits are permanently fixed in place during construction, and the davit arm is moved into position when required.

Key product features:

  • Versatile capacity: Lifts 500kg or protects three people simultaneously
  • Protects building surfaces: Projects ropes without damaging facades or balustrades
  • Flexible positioning: Removable arm relocates across multiple permanent bases
  • Safety certified: Meets EN795 Type B and CEN/TS 16415 standards
ENQUIRE NOW
COMPLIANCE
Key product features
  • Versatile capacity: Lifts 500kg or protects three people simultaneously
  • Protects building surfaces: Projects ropes without damaging facades or balustrades
  • Flexible positioning: Removable arm relocates across multiple permanent bases
  • Safety certified: Meets EN795 Type B and CEN/TS 16415 standards
Installation details

Installation should be carried out by a manufacturer-trained technician who is familiar with the parameters of fall arrest and abseil systems. 

Product warranty

The manufacturer grants a warranty for 12 months from the date of purchase of the device. The warranty covers: defects in the material, defects in workmanship, and anti-corrosion coating defects.

Maintenance

As per AS/NZS 1891.4, the Monkeytoe PSD Davit Arm must be certified every 12 months by a qualified height safety equipment inspector. After 5 years of use, it is recommended that periodic inspections be carried out by the manufacturer of the equipment or an entity authorised by the manufacturer to carry out such inspections. All the exposed materials in the system have been specified as naturally corrosion-resistant or have been coated with sacrificial coatings to prevent oxidation of the base material. It is important to consider that the system may need to be cleaned to gain the best possible life expectancy from the materials in some environments.

Monkeytoe Roof Hatch

COMPLIANCE

Conforms to EN795 Type B and CEN/TS 16415.